Search This Blog

Tuesday, August 25, 2015

AGC Bitx

In our earlier pictures for the AGC module, there was a connector placed in a wrong direction and also the trimmers were placed in the opposite direction.

We are publishing the correct placement again for the mentioned items.
Some care is to be taken in  handing the VU meter as it is quite fragile. Instead of soldering the pins of VU Meter to the AGC pcb it would be better to solder short piece of wire pair and connect to the AGC pcb.

The audio mute pcb is overlapping the PA pcb this happened as the PA pcb was modified for the diode RXcut off switch, suitable spacers can be provided to raise the hight of the audio mute pcb while fixing on the case.







Monday, August 24, 2015

DDS FOR BITX VER 3 SERIES TCVR'S

Test have been done with our DDS to be used with all our Bitx ssb tcvr's .
A 20mt Bitx3C- with SBL-1 mixer using DDS is complete and in the next week we shall pubish some
pictures of the completed set.

Pictures of the DDS we will be using in our kits. The mono band tcvr can use either FLL freq counter
or the DDS.

DDS  FOR BITX VER3 SERIES 


FRONT PANEL BITX VER 3 SERIES CASE WITH DDS

Featured Post

   My Journey with Amateur Radio: Sunil Lakhani (VU3SUA) Shares His Story Hello, fellow radio enthusiasts! This is Sunil Lakhani, also known...